T1 Hornbeam Crown Lift to provide 4m clearance from ground level, G1 Hornbeam Crown Lift to provide 2.5m clearance from shed roof, T2 Oak Crown Reduction - Reducing the height and spread of the tree by up to 2-3m, T3 Oak Crown Reduction - Reducing the height and spread of the tree by up to 2m and remove deadwood, T4 Silver birch Crown Reduction - Reducing the height and spread of the tree by up to 2m, Works to maintain trees size, and to increase light into the woodland understory. (TPO1/1971)

G1 - Woodland Tree Line - Located on boundary, to rear/side of No. 64 Boundary Way. Consisting of 2x Mature Sycamore shown as T1 & T2, located close to the boundary line, with considerable overhang to property and garden area of no.64. Reduce overhanging laterals to reduce overextended limbs of Sycamore tree by 4.5M. Remove or carry our end-weight reduction to lower limbs in close proximity to house roof line, to provide suitable crown clearance from roofline of property block. To alleviate crown encroachment and light filter issues to property and garden, while reducing end weight to crown, reducing risk of limb failure to over extended limbs. Fell X1 Self-set Sycamore T3, located close to fence boundary. height approx 6/7m Fell and remove due to low value and poor siting growing under established trees. Further crown growth will likely cause continual conflict to adj property and boundary.

T1 cedar Reduce over extending branches over the roof of the house by around 1-2m T2 willow fell, leaning/fallen over and in very poor condition T3,4,5,6 conifers fell, outgrown their area and significantly effect light levels T7&8 conifers reduce in hight by around 1/4-1/3 (back to previous reduction points) to reduce risk of failure. TPO 78W, TPO 115W.

TH/TPO/2(2007) - 1No Beech (T1) Fagus sylvatica - Crown reduce by 1-1.5m, cut back by 2-2.5m to clear roof and reduce height from 12m to 10.5m and radial spread from 6m to 4.5 - 5m, 1No Sycamore (T2) - Crown reduce by 1.5-2m, cut back by 2-2.5m from roof, reduce height from 13m to 10.5m and radial spread from 5m to 3.5-4m, 1No Horse Chestnut (T3) - Crown reduce by 2.5-3m, cut back by 2-2.5m from roof, reduce height from 15m to 12m and radial spread from 6m to 4m

Remove a dead hawthorn tree that partially collapsed into nearby trees and is overhanging the rear garden of 5 Briar Mead. In addition clear over hanging branches up to 2.5 metres from ground level that are overhanging the fence line to allow the installation of a new boundary fence and to protect the roof of the garden shed that sits underneath the trees as the felt is being ripped and damaged.

Pruning back over the kitchen roof, back to the boundary of 70 West End of one Yew tree - TPO-CCD-25-2011

T1, oak : reduce branches over neighbouring garden to clear roof by 2m by pruning to a suitable second order branch. Reduce branches over roof of Oak Cottage to clear 2m by pruning to a suitable second order branch. Re-shape remainder of crown by reduction of 1-2m to leave a natural form.

Works to a Tree with a TPO: Hand dig a trench on the perimeter of the proposed rear extension parallel to the existing house to understand the extend of roof growths and potential pruning that might be required during construction.

3no. Beech trees - Tip reduce crown the crowns of the trees on the southern and eastern sides to leave a leave a completed finished crown spread of 8m measured from the stem. Crown lift to the branches overhanging the roof of 2 Redwood drive to provide a 2m clearance over the roof. Tip reduce to provide a 1.5m clearance from the adjacent lamp column number 124 and Tip reduce the lowest branch on the northern side in line with the lamp column 124. ( 093/1983/TPO).

T1 Yew - cut back by 0.5m of the branches overhanging the footpath to a height of 6m, cut back away from the church by 2m. T2 Bay - pollard at 2.5m T3 Sorbus - clear away from the church roof by 1.5m T4 Hazel - cut down to 1.5m in height T5 Cotoneaster - cut back the lateral branches by 0.5m