1. 145a - mixed group - cut back cotoneaster to give 1.5 clearance of garage, sever ivy on honey locust - To abate a nuisance, rubbing lateral branches on garage roof. 2. 146a - oak - remove a 1m section of ivy from ground level using hand tools only - To enable clear future inspection of main stem. 3. 149c - Scots Pine - remove deadwood 25mm and greater over site only - To reduce the volume of debris, mess and damage caused by falling deadwood over the target area and reduce risk of injury. 4. 151 - beech - reduce height by 3-4m reduce lateral branches by 2.5-3m to shape, remove deadwood Carry out climbing inspection of unions. - Reduction to suitable growth points to promote new growth and to improve vitality. 5. 153 - lime - remove deadwood 25mm and greater in diameter, remove epicormic growth to height of 8m To reduce the volume of debris, mess and damage caused by falling deadwood improve light to the ground floor apartments. 6. 154 - lime - remove deadwood 25mm and greater in diameter, and hanging branch at 16m northeast side of crown remove epicormic growth to height of 8m. 7. 155 - lime - remove deadwood 25mm and greater in diameter, and hanging branch at 16m northeast side of crown remove epicormic growth to height of 8m. 8. 156 - lime - remove deadwood 25mm and greater in diameter, and hanging branch at 16m northeast side of crown remove epicormic growth to height of 8m. 9. 157 - lime - remove deadwood 25mm and greater in diameter, and hanging branch at 16m northeast side of crown remove epicormic growth to height of 8m, remove ivy from main stem. Removal of epicormic growth To reduce the volume of debris, mess and damage caused by falling deadwood over the target area and reduce risk of injury. To improve light to the ground floor apartments. 10. 162 - Tulip - Crown Lift To A Height Of 3m From Ground Levelimprove light to the ground floor apartments. - To give sufficient height clearance over the lawn and seating area of the site.

1 x Large Oak tree at rear of Blocks 1-6 - Crown reduce flats and garage side by approximately 2m and remove major deadwood. 1 x Oak tree at rear of Blocks 1-6 - Reduce long laterals by approximately 2m. SUBJECT TO TPO 1384 (11.6.1997)

Island in pond: 1 x Willow - Pollard to previous pruning points. Small Willow on side of bank - Fell to ground level. Willow (by bridge) - Reduce and shape crown by 2m leaving 4m. Rear boundary area: Various Hollies - Reduce height by approx. 4m. Line of Leylandii in front of Mitsubishi garage - Reduce height by approx. 4m and cut back on Alders side. Oak (by stream) - Cut back lateral spread growing towards flats by 2m and remove trunk growth. Horse Chestnut (adjacent to Leylandii hedge) - Remove low limb and cut back lateral crown spread growing over lawn area by 2m leaving 4-5m. Scots Pine - Remove low limb and reduce crown overhanging neighbours garden by approx. 2m leaving 3m, and remove deadwood. Small Ash (leaning over road) - Fell to ground level. Pond area: Mixed species group of trees mainly consisting of Sycamore/Alder/Ash - Thin out trees with dense crowns by 10% and raise crown to 5m, and remove deadwood. SUBJECT TO TPO 518 (3.3.1988)

Fell 1 No. sycamore tree (T1) - Significant deadwood in canopy, lead stem appears to have caused damage to the cambion/sapwood. Lawson cypress tree (T2) (Note: this is in the form of a hedge) remove damaged limbs and reduce the limbs back that are touching the nearby property by no more than 2m from distal end. Cherry tree (T3) located near garage - Crown reduction up to a maximum of 2m from distal end to suitable growth points as per BS3998. Cherry tree appears to be in good condition but is shading out nearby flats and gardens. Beech tree (T4) - Crown reduction up to a maximum of 2m from distal end to suitable growth points on property side only to stop encroachment (House). Deadwood Canopy >25mm in diameter. Beech tree ( T5) - Crown reduction up to a maximum of 2m from distal end to suitable growth points on property side only to stop encroachment (Garden). Deadwood Canopy >25mm in diameter.