Pin Oak (LHS side of property, close to boundary) - Reduce the height and spread of the tree by up to 2.5m. The lower SE, S & SW (overhanging neighbouring property) laterals have been reduced heavily in the past in an attempt to pull into shape - reduce regrowth back to suitable live growth in line with remaining canopy. All pruning cuts shall be made to suitable secondary growth points and shall maintain a stable platform for the expected regrowth. Remove any major deadwood over 20mm diameter. Suitable access for our tracked MEWP - take boards to protect lawn from track damage. Measurements: Pre works - 26x19m Post works - 23.5x16.5m.

T1. Beech (neighbours tree, tag no.0795) - Included main union at 3m where trunk divides into two co-dominant stems. Reduce the lateral spread of the canopy overhanging the rear gardens by up to 3 metres. No height to be taken out of the tree. All pruning cuts shall be made to suitable secondary growth points and shall maintain a stable platform for the expected regrowth. Any major deadwood (over 25mm diameter) above the gardens is to be removed too. T2. Sycamore (neighbours tree, tag no.0796) - Suppressed tree with squirrel damage. Reduce overhanging encroachment back to boundary line and raise canopy over rear garden of no. 11 Charlwood Place to provide 3m ground clearance. Reduction of lateral canopy spread over private gardens to allow more light into properties. 19x12m to 19x9m.

T1. Plum group front boundary - Crown Reduction. Reducing the height and spread of the tree by up to 2 metres. All pruning cuts shall be made to suitable secondary growth points and shall maintain a stable platform for the expected regrowth 8x7m down to 6x5m encroaching on drive entrance 11. Yew rear garden of 23 - Crown Reduction. Reducing the height and spread of the tree by up to 1 metre. All pruning cuts shall be made to suitable secondary growth points and shall maintain a stable platform for the expected regrowth

AMENDED SPECIFICATION FOR T3 SEE CONDITION 2 T1. Chestnut front boundary - Crown bias to the north. I would recommend a Crown Reduction. Reducing the height of the tree by up to 2 metres and the northern canopy by up to 1 metre and reduce the protruding limb to the west by 2 metres. All pruning cuts shall be made to suitable secondary growth points and shall maintain a stable platform for the expected regrowth. 17x12m down to 15x11m works to balance and tidy the tree following the loss of the adjacent tree in previous storm. T2. Lime front boundary - Historically been reduced with approximately 6-7 metres regrowth from old points with obvious decay at these points, I would recommend a Crown Reduction. Reducing the height and spread of the tree by 3-4 metres. All pruning cuts shall be made to suitable secondary growth points and shall maintain a stable platform for the expected regrowth. Raise crown over road to provide 5 metres clearance from ground level by the removal of secondary and sub-branches. 20x15m down to 16x12m works to alleviate the stress on the old decaying pruning points and allow light into the front of the property. T3. Cedar front boundary - Crown Thin. Removing selected branches in the upper canopy to reduce current density by up to 15% remove broken / damaged branches and major deadwood greater than 20mm in diameter. Raise crown over road to provide 5 metres clearance from ground level by the removal of secondary and sub-branches. 18x12m tree. works required to prevent further storm damage