Variation of Condition 2 'Approved Plans' of planning permission 19/AP/0545: Construction of a side and rear single storey extension Variations sought: - Changing the approved flat roof section showing on approved drawing ref:1807 -15-a to be replaced with gable roof so there is one gable roof to rear instead of a mixture of gable and flat roofs. - Maintain the approved ridge height at that point. The approved parapet wall will be reduced in height to what have been approved as a result. - Existing bathroom window will be slightly reduced in depth to accommodate the flashing to the wall. Roof light on that side instead of the flat roof light. - The small section of the flat roof adjacent to the external dining room wall will be replaced by taking the lean to roof all the way to that wall so in effect the appearance on that particular section will not looked altered when looking from the rear garden, and this will not have any negative impact or adversary on the adjacent property, but there will be a slight increase of the volume as a result as this section. The window of the dining room will not be reduced in height as approved but part will be blocked where the rafters of the lean to roof abut it this will allow keeping the main feature of the window and at the same time allowing visual connection into the proposed extension and the rear of the garden. The opening at the rear wall will be reduced to a set of bifold doors which the overall width is less than the combination of the French doors and large window. Internally the proposed cloak room is omitted in favor of a better kitchen layout.

Variation of Condition 1 'Approved Plans' of planning permission ref. no. 22/AP/3025: Installation of a new operational roof top plant including strobic extractors, generator and acoustic louvers, condenser units located on existing balconies, replacement windows and access doors and the installation of louvers within the facade. Variation sought for: - removing the two approved acoustic plant louvre screens; - replacing an approved rooftop plant louvre at the centre, with a new one exceeding 3.35m in height from the roof level (level 10) to house a new strobic extractor; - retaining the existing ground floor doors on the north elevation; - reverting the approved louvres to the existing windows on the north elevation at level 5

Variation of Condition 1 (Appoved plans) to planning application 23/AP/1159 dated 22/06/2023 for Variation of Condition 1 'Approved Plans' of planning permission ref. no. 22/AP/1464: Variation of Condition 1 (approved plans) pursuant to planning permission 20/AP/2261 for 'Demolition of rear extension and construction of new first and second floor rear extension to existing flats, the change of use of the ground floor commercial units to create 1 no. residential unit and the construction of a new mansard roof to create 1 no. residential unit' to replace the first floor and second floor parapet windows for Juliet balconies at the rear of the property, and widening of ground floor rear glazing. Variation sought: to omit the creation of the new unit, and the extension of the existing property through the mansard extension. Current changes proposed are: Amend rear windows and terraces to add balconies for private amenity space at first, second, and third floors. Installation of solar panels to roof

Variation of Condition 1 'Approved Plans' of planning permission ref. no. 22/AP/1218: Construction of single storey rear extension, hip to gable roof conversion and mansard roof extension to rear with Juliet balconies, new rooflights to front slope of main roof, increase in height to existing chimney and new enclosed storage area to side access passage and pergola to garden. Variation sought: - 1.6m Extension into garden (increase of 400mm over what is already permitted). - New side window. - One side window bricked up in matching bricks.

Variation of Condition 1 'Approved Plans' of planning permission ref. no. 22/AP/4127 for 'Garden office with external decking at the end of the rear garden' to replace the garden office window with patio styled doors.

Details of Condition 3 'Sample of Mono Histoglass' pursuant to planning permission 23/AP/0889: Variation of Condition 1 'Approved Plans' of planning permission ref. no. 22/AP/3564: Alterations including amalgamation of existing studio flat back into single dwelling house; internal reconfiguration works; alterations to existing rear extension including addition of rooflights and changes to rear fenestration with formation of single large opening and new cladding; rendering of exposed brick lintel detail to first floor rear elevation, replacement of existing single glazing to windows with Mono Histoglass glazing. Variation sought: Minor changes as follows: -Omit a 750mm x 2200mm new rooflight, and install an approx. 750mm x 3300mm new rooflight to the modern flat roof extension. -Omit a 750mm x 2200mm new rooflight, and install an approx. 800mm circular rooflight and the location adjusted. -The new metal frame double glazed doors to the modern flat roof extension have been revised in opening method only, to be sliding instead of bi-fold doors. -Removal of a modern masonry wall beside hallway to be replaced with partition at upper ground floor level

Details of Condition 5 (Internal Noise Levels) pursuant to planning permission ref: 22/AP/2989 granted on 18/10/2022 for: (Variation of condition 1 (approved Plans) of planning permission ref: 19/AP/0084 granted on 26/11/2021 for (Retention of public house (Sui Generis use class) at the basement and ground floor, conversion of the upper floors to provide x1 two-bed flat and x2 one-bed flats (Use Class C3) (total: x3 residential units), including a second and third floor rear extension and minor alterations to existing window and door openings to side elevation, and provision of associated refuse facilities) -to allow the change in the material of the rear extension from clad timber slate to Zinc.

Details of Condition 4 (Validation test regarding the sound reduction and level of insulation) pursuant to planning permission ref. no. 22/AP/2989: Variation of condition 1 (approved Plans) of planning permission ref: 19/AP/0084 granted on 26/11/2021 for (Retention of public house (Sui Generis use class) at the basement and ground floor, conversion of the upper floors to provide x1 two-bed flat and x2 one-bed flats (Use Class C3) (total: x3 residential units), including a second and third floor rear extension and minor alterations to existing window and door openings to side elevation, and provision of associated refuse facilities) -to allow the change in the material of the rear extension from clad timber slate to Zinc.

Variation of Condition 1 'Approved Plans' of planning permission ref. no. 21/AP/4752: Basement Extension (as the property footprint) and single storey rear extension on the ground floor with sunken terrace. Variation sought: - Increase the height of the rear extension (single storey ground floor). - Increase the height of the windows and doors. - Insertion of basement level window. - Changes to roof light dimensions.

Non-material amendment to condition 2 (approved plans) of planning permission dated 18.08.2015 ref. 14/AP/2922 for: "Variation of Condition 2 (approved plans) of planning permission 12/AP/3558 dated 04/06/2013 for the 'Demolition of existing buildings and erection of a replacement building of five to eight storeys in height (max height of 27.5m), plus basement, comprising 53 residential units, 633 sqms of retail floorspace (Use Class A1) and 767 sqms of office floorspace (Use Class B1), disabled parking spaces and roof top landscaped amenity areas'. Proposed changes incorporate: - Alterations to internal floor plan layouts and core layouts. - Realignment of window and door positions to correct inaccuracies with plans. - Removal of brick pillars to balconies and provision of opaque glass balconies. - Increase in height of building by 150mm to accommodate lift overrun. - Increase in A1 floorspace from 643.2sqm to 721.9sqm. - Reduction in B1 floorspace from 670.3 to 645.64sqm. - Alteration to building line/arrangement at Ufford Street/Boundary Row junction." The non-material amendment comprises the extension of the existing plant enclosure located on the seventh floor of Block B to accommodate an additional condenser unit to support the operation of the commercial uses.