To identify the tree of concern I have attached a Tree Survey File. On the drawing the tree is seen on the border of plot 2 and plot 3 labelled "Leylandii". Since the survey was completed the land has been sold for development and the resultant plots are slightly different resulting in the tree being on the very border of plot 2. I am the owner of plot 2. I will also include a few pictures of the tree. The tree is very large and over bearing. I would like to replace the tree with a number of smaller trees distributed around the plot. Design to be established by a landscape professional should approval be possible for the removal of the large tree,

T1 Lime- Back right- reduce height by 2.5 metres and sides by 2 metres and allow light through T2 Lime- Back right- reduce height by 2.5 metres and sides by 2 metres and allow light through T3 Lime- Back right- reduce height by 2.5 metres and sides by 2 metres to allow light through T4 Lime- Back right- reduce height by 2.5 metres and sides by 2 metres to allow light through T5 Lime-Back right- reduce height by 2.5 metres and sides by 2 metres to allow light through T6 Lime-Back right- reduce height by 2.5 metres and sides by 2 metres to allow light through

T1 - Silver birch x 1 - fell to ground level Reasons: complaints from neighbours

T1 - Western Red Cedar - Reduce height by 3.00 meter to allow light into house and garden

Various tree works

T1 - Spruce x 1 - lift to 8m above ground level, thin crown by 20% Reasons: outgrowing a restricted location and blocking light

Please refer to separate document TPO Works 15-8-23. TPO 735 applies to a Sycammore tree in the rear garden of my house.

T1 Lime- Back right-Pollard by 50% 10 metres to take dead branches out and allow light through T2 Lime- Back right-Pollard by 50% 10 metres to take dead branches out and allow light through T3 Lime- Back right- Pollard by 50% 10 metres to take dead branches out and allow light through T4 Lime- Back right- Pollard by 50% 10 metres to take dead branches out and allow light through T5 Lime- Back right- Pollard by 50% 10 metres to take dead branches out and allow light through T6 Lime- Back right- Pollard by 50% 10 metres to take dead branches out and allow light through

01 - Conifer - cut back laterals to clear the property by 4 meters 01 - To create enough clearance so as squirrels cannot access the property. 02 - Sycamore - Cut back laterals to clear the building by 4 meters. 02 -To create enough clearance so as squirrels cannot access the property. 03-Sycamore - Cut back laterals to clear the building by 4 meters. 03 - To create enough clearance so as squirrels cannot access the property.

The tree on which works is to be done is identified by T1 in a blue circle in the attached document (Tree Identification) and also by a circle in the Sketch Plan The tree needs to be pruned as it's very tall and slender and hence the top and some side branches sway in windy conditions posing danger to the fences and also to persons in my garden and to pedestrians on the adjoining verge. The tree should be pruned as follows: 1. The tree is bent on the top and could sway and shear in windy conditions. This could damage the fences on my property and also on neighboring properties. 2. The branch to the left drooped very much and could fall posing danger to the nearby fences and also to persons in my garden 3. The small Branch on the right is drooping and if it falls, can cause damage to the pedestrians on the verge along A404 adjoining my house These 3 pruning points on the tree are identified in the attached Tree Photograph